TIPS AND TRICKS
by
Warren Feld
blog.landofodds.com
Occasional insights into beading, jewelry making, and business…
CURRENT TIPS AND TRICKS BLOG ARTICLES
THREADING YOUR NEEDLE
There are two ways to thread a needle. The logical way, the way your mind and brain and eyeball and heart and gut all say to do is this:
- Take the thread in one hand, and the needle in the other. Push the needle onto the thread. Keep poking the thread with the needle until the thread meets the hole and slips through. Then pull on the thread.
The illogical, but more correct way, is to pop the thread into the needle:
- Put the thread between your thumb and fore-finger, and pinch it. Pull it down between your fingers so that the end slips just below the top surface of your fingers. Place the needle over your fingers, lining up the eye hole just above the gap between your two fingers where the thread is hiding, and keep the needle from moving. Squeeze your thumb and forefinger together, so that the thread pops straight up and into the eye-hole. Voila! Magic. Then pull on the thread.
When cutting your thread off the bobbin or spool, if you cut at a slight angle,
it makes it easier to get the thread through the eye hole of the needle.